mirror of
https://github.com/dragonpilot/dragonpilot.git
synced 2026-03-03 11:53:58 +08:00
25 lines
671 B
Markdown
25 lines
671 B
Markdown
# In-circuit debugging using openocd and gdb
|
|
|
|
## Hardware
|
|
Connect an ST-Link V2 programmer to the SWD pins on the board. The pins that need to be connected are:
|
|
- GND
|
|
- VTref
|
|
- SWDIO
|
|
- SWCLK
|
|
- NRST
|
|
|
|
Make sure you're using a genuine one for boards that do not have a 3.3V panda power rail. For example, the tres runs at 1.8V, which is not supported by the clones.
|
|
|
|
## Openocd
|
|
Install openocd. For Ubuntu 24.04, the one in the package manager works fine: `sudo apt install openocd`.
|
|
|
|
## GDB
|
|
You need `gdb-multiarch`.
|
|
|
|
Once openocd is running, you can connect from gdb as follows:
|
|
```
|
|
$ gdb-multiarch
|
|
(gdb) target ext :3333
|
|
```
|
|
To reset and break, use `monitor reset halt`.
|