History

huifan 80012cdf7a Revert "Compile FrogPilot" This reverts commit `0d501cfab2`.		2024-11-04 21:54:14 +08:00
..
README.md	Revert "Compile FrogPilot"	2024-11-04 21:54:14 +08:00
debug_h7.sh	Revert "Compile FrogPilot"	2024-11-04 21:54:14 +08:00

README.md

In-circuit debugging using openocd and gdb

Hardware

Connect an ST-Link V2 programmer to the SWD pins on the board. The pins that need to be connected are:

GND
VTref
SWDIO
SWCLK
NRST

Make sure you're using a genuine one for boards that do not have a 3.3V panda power rail. For example, the tres runs at 1.8V, which is not supported by the clones.

Openocd

Install openocd. For Ubuntu 24.04, the one in the package manager works fine: sudo apt install openocd.

To run, use ./debug_f4.sh (TODO) or ./debug_h7.sh depending on the panda.

GDB

You need gdb-multiarch.

Once openocd is running, you can connect from gdb as follows:

$ gdb-multiarch
(gdb) target ext :3333

To reset and break, use monitor reset halt.