* Exit power saving also for CAN based ingition detection and replace interrup with simple state machine. a bit of delay it's fine
* bug fixes and also CDP set on start
* sorry misra
* move comment
* typo
* remove ignition interrupts
* Power saving state machine should be done by boardd, which also sets safety modes and usb power modes
* typo
* Added usb command for power save state setting
* Added power save enabled packet
* Added power_save_enabled to python lib too
* late usb
* Added type support for black panda
* Added harness presence and orientation detection
* harness relay driving code
* Added intercept support in black panda code. Switched around can0 and can2
* Disable ADCs after orientation detection. Ignition interrupts via harness
* WIP: Hardware abstraction layer + black panda bringup
* Fixed bootstub build
* Fixed bootstub for pedal
* Fixed infinite loops
* Got CAN buses working on white again
* Fixed pedal build and black can interfaces
* Got CAN buses working on black panda
* Finished loopback test for black panda
* Erase all flash sectors on the panda. Increased binary limit. Added extra python functions.
* Fixed python
* Made new code MISRA compliant
* Cleaned up ignition. Fixed build
* Fixed health packet
* Fixed CAN mode on black bug. Changed OBD to switch on ELM mode
* Fixes from Github review
* Fixed MISRA issue for pedal
* Fixed failing gmlan tests
* ELM327 safety: allow diagnostic on all buses
* Cleaned up EON relay code
* delete only 3 sectors instead of 11 to allow a new build to be flashed. Much faster to flash
* Removed CAN only can0 output mode. Does not make sense on black panda due to reversibility issues.
* Added heartbeat logic for EON code on panda. Go to NOOUTPUT if EON does not send a heartbeat for 5 seconds.
* Remove all CAN buses live on EON startup. Shouldn't be necessary to have this separate case
* Formatting
* Added file I forgot to push
* Added heartbeat to testing code to make sure EON tests don't fail. Should probably find a better way to do this though. Heartbeat thread didn't work, concurrent USB connection issues...
* Safety: support black panda for Honda Bosch
* Disable OBD2 if setting to NOOUTPUT mode
* Run safety tests for all hw_types
* Fail test if subtest fails
* fix safety tests
