mirror of
https://github.com/dragonpilot/dragonpilot.git
synced 2026-02-19 21:44:01 +08:00
84a3c355e5
* change LSM6DS3TR(-c) gyroscope and accelerometer to interrupt * add pthread for linking * add interrupt collector thread to fetch in parallel to non interrupt based sensors * change get_event interface to return true on successful read * fetch sensor interrupts via gpiochip * avoid sending empty messages (interrupt only, non interupt magn can leave a gap in the orphan block) * add verifier script to sensor interrupts (sensor_data_to_hist.py) * add/update sensord testsweet (test_sensord.py) * add poll timed out check * unexport interrupt gpio pins * gpiochip on both edges, but skip falling edge if rising edge is detected, this is handled in the sensor as the status flag is checked if new data is availble * add test to sensord to verify 100Hz interrupt frequency * add sensor shutdown/low power mode functionality on sensord exit * relax test, will be readded in the splitup PR Co-authored-by: Kurt Nistelberger <kurt.nistelberger@gmail.com>
debug scripts
can_printer.py
usage: can_printer.py [-h] [--bus BUS] [--max_msg MAX_MSG] [--addr ADDR]
simple CAN data viewer
optional arguments:
-h, --help show this help message and exit
--bus BUS CAN bus to print out (default: 0)
--max_msg MAX_MSG max addr (default: None)
--addr ADDR
dump.py
usage: dump.py [-h] [--pipe] [--raw] [--json] [--dump-json] [--no-print] [--addr ADDR] [--values VALUES] [socket [socket ...]]
Dump communication sockets. See cereal/services.py for a complete list of available sockets.
positional arguments:
socket socket names to dump. defaults to all services defined in cereal
optional arguments:
-h, --help show this help message and exit
--pipe
--raw
--json
--dump-json
--no-print
--addr ADDR
--values VALUES values to monitor (instead of entire event)
vw_mqb_config.py
usage: vw_mqb_config.py [-h] [--debug] {enable,show,disable}
Shows Volkswagen EPS software and coding info, and enables or disables Heading Control
Assist (Lane Assist). Useful for enabling HCA on cars without factory Lane Assist that want
to use openpilot integrated at the CAN gateway (J533).
positional arguments:
{enable,show,disable}
show or modify current EPS HCA config
optional arguments:
-h, --help show this help message and exit
--debug enable ISO-TP/UDS stack debugging output
This tool is meant to run directly on a vehicle-installed comma three, with
the openpilot/tmux processes stopped. It should also work on a separate PC with a USB-
attached comma panda. Vehicle ignition must be on. Recommend engine not be running when
making changes. Must turn ignition off and on again for any changes to take effect.