* add metric values
Freedom units have weird multiples compared to metric. Modified so that it increments by 10 km/h on long press and 1 km/h on short press, rather than 8 and 1.6 km/h. This mimics stock hyundai behaviour on metric vehicles.
* use is_metric from controlsd
* use actual mph value instead of rounded
Co-authored-by: Willem Melching <willem.melching@gmail.com>
* just use MPC for fcw checking
* thats already bad
* model FCW is always good
* better fcw
* should be good for now
* comment
* linting
* cleaner
* unused
* panda
* bring over changes
* dont check car model
* remove comment
* fix typo
* more stuff gated behind long
* not
* not used
* gate that too
* try honda tuning
* clip accel values
* fix up merge
* fix stopping
* add retry logic around knockout
* increase timeout
* keep flipping lead bit
* true for now
* less tuning
* update comment
* 0.1 s is fine now
* merge honda and hyundai knockout
* more lead fields
* another obj bit
* increase timeout
* fix stopping flag
* only lag compensate for braking
* no lead
* less tuning
* only do knockout if not readonly
* try controlling using jerk
* tuning
* try higher stopping rate
* set stopping flag at higher speed
* clip upper jerk when stopping
* remove comments
* tester present 1hz
* use positive start accel
* 1.0 to maybe improve low speed stuff
* no point going over 0
* bump panda
* bump panda
* revert that change
* update ref
* use ISO 15622:2018 limits in PID controller
* allow more for nidec
* limit PID inputs
* CP is not needed
* add GM
* not used
* update ref
* fix honda bosch
* add higher set speed
* freeze when close to cruise
* dont bias this
* higher set speed
* start high
* 2mph might be needed
* better condition
* limit accel windup like this
* wrong name
* retune civic
* seems smooth
* back to normal
* new ref
* fix conflict
* runs
* rm
* accel scale is 4
* toyota should be good
* more cleanup
* fixup
* better naming
* update ref
* deprecated
* sending brake when not enable causes a fault
* rm gas and brake
* unused
* update ref
* acura logic is no more
* wrong before
* revert tuning cleanup
* adress comments
* update ref
* already on master
Co-authored-by: Willem Melching <willem.melching@gmail.com>
* Mazda CX-9 no steer lockout, and newer cars can use more torque
Signed-off-by: Jafar Al-Gharaibeh <to.jafar@gmail.com>
* Mazda CX-9 2021 test route
Signed-off-by: Jafar Al-Gharaibeh <to.jafar@gmail.com>
* cleanup
* more cleanup
* don't show community features alert if dashcam only
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* refactor
* needs casting
* tests pass
* fix that test
* refactor in controls
* lets not go crazy
* change of names
* use constants
* better naming
* renamed
* soft constraints
* compile slack variables
* rm git conflict
* add slack variables
* unused
* new edition
* fcw
* fix tests
* dividing causes problems
* was way too slow
* take a step back
* byeeee
* for another time
* bad idxs
* little more cpu for cruise mpc
* update refs
* these limits seem fine
* rename
* test model timings fails sometimes
* add default
* save some cpu
* Revert "little more cpu for cruise mpc"
This reverts commit f0a8163ec90e8dc1eabb3c4a4268ad330d23374d.
* Revert "test model timings fails sometimes"
This reverts commit d259d845710ed2cbeb28b383e2600476527d4838.
* update refs
* less cpu
* Revert "Revert "test model timings fails sometimes""
This reverts commit e0263050d9929bfc7ee70c9788234541a4a8461c.
* Revert "less cpu"
This reverts commit 679007472bc2013e7fafb7b17de7a43d6f82359a.
* cleanup
* not too much until we clean up mpc
* more cost on jerk
* change ref
* add todo
* new ref
* indentation
* untested changes
* set compute_gb
* community feature for good measure
* add code for rolling backwards
* init needs CarParams
* stay in elm mode until carParams is written
* fix tester present bus number
* fix can errors
* fix enableCruise flag
* print when radar disable is done
* move retry logic to controlsd
* move lookup table into carcontroller params
* cleanup brake error values
* make init return
* that should be 1
* floats
* back to no failure handling
* try simplify knockout
* bump panda
* Move flags to panda
* add warnings
* Revert "try simplify knockout"
This reverts commit 4f496245791ea6bd041d4412b96035c6b434b91c.
* add note about LoC.long_control_state
* update ref
* some common changes
* rename to joystick
* add alert and update controlsd to work with joystick
* update joystickd
* Update Joystick readme
* assume we have inputs
* only send gb or steer when engaged_toggle is true
* Update instructions
* fix --ip
* Easier to understand at a glance
* much better
* -a
* receive events and send msg in same loop
* always import
* Update selfdrive/controls/lib/events.py
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* Update selfdrive/controls/lib/events.py
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* combine logic and clean up
* use argparse
* outdated, and use normal class
* rm
* bit of a refactor
* refactor part 2 / 3
* much better (3 / 3)
* Simplify
* bump cereal and update readme
* capitalize
* Update tools/joystick/joystickd.py
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* Update tools/joystick/joystickd.py
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* make joystick abstraction class clearer
* use interp, clearer without comments
* no need to use apply_deadzone
* more explicit
* define btns and axes once
* split function by use_keyboard again, but simpler
* we can use handle_button as a reset function
* need to flip sign
* remove
* invert axes map for kb, easier to read the button mapping
* apply changes from review
* new lateral log for debug mode
* bump
* add saturated
* static alert
* joystick_mode
* conditionally subscribe
* Update selfdrive/controls/controlsd.py
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* move params instantiation
* Spoof active and enabled
* Only allow car to engage
* no startup alert if joystick
* Update controlsd.py
* Should be orange not enabled, green enabled
* no more button states
* should work
* blue
* submaster conflates, so only send when we have an update
* final change
* remove msg
* clean up a bit
sort of clean up
clean up a bit
remove msg
* this was right
* Apply suggestions from code review
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* lowercase
* suggestions from code review
* forgot laptop
* bump to latest
* fixes
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
Co-authored-by: vanillagorillaa <31773928+vanillagorillaa@users.noreply.github.com>
* New model: 51a237cd-9c43-4281-9072-802325e6744d/950
* Added new meta outputs and proper interp for plan_t_arr
* Added meta-based trigger for FCW
* No nans in planner, separate alert for model FCW
* Cleaned up plan_t interp logic
* Added empty cameraError alert to fix unit tests
* Use the normal FCW event
* Updated filter logic
* Updated model replay ref
* Moved disengage predictions into their own cereal struct
* Updated model replay ref for new cereal structs
* Apparently this breaks stuff?
* Bumped cereal commit and model replay ref
