* draft
* bump opendbc
* still draft
* that's not right
* superset of the changes, 33hz
* cleanup
* this should work
* remove line
* pass it in again
* actually no need to check updated now
* now_nanos
* consistent name
* fix replay
* one line isn't that bad
switch
switch
* fix CarController tests
* Update ref_commit
* Reliable relay open
* Reliable relay close
* ign in a loop
* fixes
* we need this
* log
* comment to remind me tmrw
* ign fix
* this makes it 2x more reliable, but messyyy
* Revert "this makes it 2x more reliable, but messyyy"
This reverts commit 03401dc4a705cfacbe5a7048d95dccb6fa80d57f.
* revert non-related stuff
* comments, spaces
* a stands for indefinite article
* not applicable for non-camera acc
* something...
* Revert "something..."
This reverts commit de8a158488efd5ef257434fbc3c55aefff800cb7.
* Update ref_commit
* stash
* more test
* less test
* clean test
* no angle
* add tolerance
* fix gm
fix gm
* test both
* lower some rates on hkg
* stash
* simpler
* bump panda
* Revert "bump panda"
This reverts commit f2137c221145cca723fe6ee3378ba947b7061965.
* only torque
* make kona pass
* duplicate __init__
* move
* half clean up
* half clean up
* more clean up
* more clean up
* fix static analysis
* calculate over 0.5 seconds
* limit to max steer
* type annotation
* calc once
* put gm camera voacc behind disable radar toggle
* bump panda
* bump panda
* bump panda
* experimental long
* fixes
* car control notes and fixes for Bolt EUV
* might enable stop and go
* consistent name
* min enable speed seems to be around 5 kph
* camera acc can engage under 5 kph if stopped
* comment
* comment
* remove this for now
* only real brake
* comments
* update max brake
* bump
* clean up/fix
* same if
* simplify
* fix
* old comment
* no brake_pressed
* temporary fault fix
* tune longitudinal
* update docs
* bump panda
* GM camera ACC cars have no regen in ACC
* cleaner
* cleaner
* fix
* set max gas
* fixes
* fix LKAS unavailable warning from camera
* only camera
* bump panda
* bump panda
* bump panda
* bump panda
* clean up gmcan
* clean up CC
* flip
* rm
* rm comment
* clean up
* custom starting/stopping probably not needed
* Update selfdrive/car/gm/carcontroller.py
* fix crash
* long tuning
* we need long control state to resume
* CAMERA_ACC_CAR not needed
* no interp on accel
* tuning
* formatting
* formatting
* formatting
* formatting
* formatting
* no need to init ccp
* makes more sense now
* send at 10hz when inactive
* try to make it fine to switch rates
* fix rate
* todododo
* fine if we skip, we usually send too early
* clean up
* this may be required, 50Hz is not really needed to sync/initialize
* preserves previous behavior (not sure if this makes sense)
* Revert "preserves previous behavior (not sure if this makes sense)"
This reverts commit 3b297bca72307b5cba09bec4e2cd8e0f2761af42.
* Revert "this may be required, 50Hz is not really needed to sync/initialize"
This reverts commit a6b4693814214d3f508db922f3b371c402a13995.
* rm com
* Update ref_commit
* gate behind GM Cam
* common logic
* bet
* update refs
* add delay to GM camera ACC cancel to avoid FCW and cruise fault
* we can revert brake pressed threshold now
* bump panda
* add proper threshold
* bump
* bujmp panda
* add all signals
* try to forward this PSCMStatus
* fixes
* see if this works
* modify checksum when bit flipped
* bump opendbc
* so i can test without restarting
* bump
* bump panda
* clean up
* comment
* also fix this
* bump
* bump
* every 5 seconds
* only send our values
* fix
* try sending everything again (+1 counter)
* revert
* revert, forward msg
* forward
* fix that
* bump panda
* bump panda
* fine to not copy
* after cancel, pass bus
* fix
* Revert "fine to not copy"
This reverts commit 654ac1a7dad4f7b9b0a3de52768522fb60cc55bd.
* GM camera ACC: no faults on start up 2.0
And by 2.0 I mean we don't need to wait for blocked msg support to be merged first to merge this without regressing accidental single blocked msg count handling.
* Send the camera counter + 1
* Keep updating the first counter until we get a message on the bus
* Only update right before sending so sent_lka_steering_cmd is updated first
* Update ref_commit
* Switch to ECMPRDNL2 for GM gear
* Removing manumatic gear #
* values.py almost complete
* Silverado and Bolt EUV val and CP
* GM controller updated
* Cam hrns supp done (in theory)
* cleanup for new cars
* Remove extra constant
* WS, etc cleanup
* removing the unused
* Fix kpBP typo
* Updated docs
* Skip's PIF tune
* Dropped LKA CAN error patch
* Add silverado sigmoid ff
* CAN Err & LKA latch patch
* Remove EPS fault fix (another PR)
* Remove Silverado (another PR)
* clean up some common params
* Remove Escalade FP
Remove Escalade FP
* comment
* Premier is just a trim
Premier is just a trim
Premier is just a trim
* no footnote: new Bolt is like most other cars, older GM were outliers not at the camera
* clean up
clean up
* bump panda
* bump panda
* bump panda
* bump panda
* bump panda
* remove comments
* try spamming buttons on bus 2
* bump panda
* bumping opendbc w btn rc
* not needed for this port
This reverts commit 6af1f0ba799e075f877d7acc8ca0f117d97da361.
* add button safety
* Send next rc when spamming btns
* forward other signals in message
* missing DriveModeButton
* fill cruiseState.speed
* see if resume works without counter
* try the whole message
* send immediately and at 10Hz
* no resume, back to just button signal
* even holding random buttons it cancels
* Use torque controller with base tune
* stock long GM don't auto-resume yet
* Testing GM zero min steer speed
* Revert latcontrol
* revert opendbc
* latActive is basically lkas_enabled
* Update Bolt torque params
* comment
* clean up
* Add to releases
* Add test route
* Don't specify segment
* bump panda
* bump panda
* no harness for Bolt just yet
* Apply suggestions from code review
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* We support all and 2023
* move safetyParam up to first cam check
* Bump panda and update docs
* Update RELEASES.md
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
Co-authored-by: Shane Smiskol <shane@smiskol.com>
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* GM: separate EV/ICE gas/brake lookup tables
* removed blank line
* V are the same
* comment
better ordering
comment
comment
* Add some delay for the laggy brakes
Add some delay for the laggy brakes
* move actuator to only acadia
* start braking at 0 m/s/s
* Revert "start braking at 0 m/s/s"
This reverts commit 55c1dee733aab3dc037fb1705c9bd0ace55c849f.
* add delay for escalade
* revert EV changes
* Update selfdrive/car/gm/carcontroller.py
* comment
* only ACADIA
Co-authored-by: Shane Smiskol <shane@smiskol.com>
* Interface radarOffCan set, comments
* pass pcmCruise value to common events
* add transType and networkLoc to iface
* carstate use transtype to detect EV
* ctrl: limit sends by config
* Add clarifying comments for new vals
* clean up
* comment on new line
* these have the same frequency
* remove 25hz
* add to upper comment
* update refs
* update refs
* move into same block
move into same block
Co-authored-by: Shane Smiskol <shane@smiskol.com>
* do tesla
* parentheses
* Do Chrysler
* Make sure Hyundai long never actuates when long inactive
.
* clean up Hyundai
* more clear
* formatting
* Stock sets these to zero
* fix params
* move jerk logic into CC
clean up
* proof of concept
* actuators packet describes which actuators are active
* bump cereal
* fixes
* not needed for this PR
* Do Toyota
* add back controlsState.active
* bump cereal
* rest of cars
* in actuators
* add active back
* which
* use controlsState.active for now
* will make an issue
* Update selfdrive/controls/controlsd.py
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* move local lat_active checks into CC.latActive
* remove redundant checks
* move comment
move comment
* fix joystick mode
* get enabled from carcontrol
* do standstill check in controlsd
* make sure we consider the gas press case for GM
* use CC.actuators
* fix
* capitalization
* Bump cereal
Bump cereal
* make intermediate actuators
* similar convention to before
* clean that up
* update refs
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* check in tuple instead of list
* Update selfdrive/car/toyota/carcontroller.py
Co-authored-by: Willem Melching <willem.melching@gmail.com>
* Update selfdrive/car/mazda/interface.py
Co-authored-by: Willem Melching <willem.melching@gmail.com>
Co-authored-by: Willem Melching <willem.melching@gmail.com>
* retune civic
* seems smooth
* back to normal
* new ref
* fix conflict
* runs
* rm
* accel scale is 4
* toyota should be good
* more cleanup
* fixup
* better naming
* update ref
* deprecated
* sending brake when not enable causes a fault
* rm gas and brake
* unused
* update ref
* acura logic is no more
* wrong before
* revert tuning cleanup
* adress comments
* update ref
* already on master
Co-authored-by: Willem Melching <willem.melching@gmail.com>
* Emit correct alerts for LDW Left & Right on Subarus
This change switches the ldw event to use VisualAlert.ldw and
alters all cars to use the prior behaviour for that alert, except
global subarus - they emit the correct warning to the dash
* Remove whitespace, and add comment about not overwriting stock alerts
Co-authored-by: Crispin Flowerday <crispin@theflowerdays.com>
